发布时间：2018-11-23 来源：澳门威斯官网平台-新威尼斯 浏览：次
Testing machine should pay attention to some issues in daily operation,can better maintenance, prolong the service life, the share of hydraulic universal testing machine daily maintenance matters with you,
The 1 test machine should always wipe clean, the application of no paintsurface wipe clean after cotton dip a small amount of oil and then wipe it again, to prevent rusting,
During the rainy season should pay attention to cleaning, when not in use and dust cover to prevent dust intrusion.
2 control cabinet all valve should not be open place, so as to avoid dust entering the inner, sensitivity measurement mechanism caused by short circuit aging effect.
3 may lead to reduce the amount of oil or deterioration frequently used for a long time, should according to the use of every check 1-3 months of the first oil. This equipment is stopped after 15 minutes, to observe the oilwindow,
If the oil level is lower than the oil window is added to the sameintermediate position of the hydraulic oil to the oil window; if the oil has been deterioration, must put on new hydraulic fluid.
4 the frequent use of the equipment to do the tensile breaking test may lead to some loose fasteners.
5 according to the environmental conditions and the frequency of use,every 3-6 months for the lubrication of the following parts:
6 beam and the moving beam on each jaw clamping device with 2 jaws, is an important part of the machine, should according to the use of often remove jaw clamping plates and the crossbeam on contact surfacedebris, so as to avoid rough contact surface. Method: remove the sideplate is moving crossbeam, remove the jaw clamp, oil cloth respectivelycontact surface of the jaw plate and beam clean, coated with an appropriate amount of butter and graphite mixed fat, fixed screwtightening clamp jaw clamping back after.